View Single Post
  #124  
Old 09-29-2008, 02:49 AM
JesusJones JesusJones is offline
AK Member
 
Join Date: Dec 2007
Posts: 187
Yes I do have a tube tester. B&K model 606 tests if its good or not, shorted, or if its grid is leaking/or gassy it claims. It works but I am not sure of it's accuracy(needs fine tuning I'm guessing but it works).

Most of the resistors I have checked have capacitors or something blocking them off from any parallel paths and what not. Or would this still be way off.

The 470 ohm resistor that goes to pin 2 of the video amp checks in at 530 ohms

The path from v5 to v6's first grid also checks in OK. Although I noticed there is no resistor in parallel with the second inductor after pin 8 from v5.(Change in production?)
Oh and the contrast 500 ohm resistor is fine. It makes the screen brighter and duller as of right now.

And the horiz. output gets it's voltage from the flyback trans. At the bottom it has connections 1 and 2 that go off to the left and go to the plates and cathodes and grids of some of the tubes? Does the current the horiz output draws affect those voltages.Or are they not connected in that way.

Voltage Readings soon tomorrow




Hehe Racoons keep waking my dog up then she starts barking. So I go outside with a bucket of cold water (and it's already cold out) and..well.. you can imagine the rest. They Don't Like That.
Reply With Quote