View Single Post
  #2  
Old 09-25-2008, 11:21 PM
classictv80s classictv80s is offline
VideoKarma Member
 
Join Date: Sep 2008
Location: Southern California
Posts: 77
Quote:
Originally Posted by freakaftr8 View Post
Thats the switch.. You'd be best to get an ohm meter and test that switch for continuity to start with.. If it's good go along with what Radiotvnut said about checking your b+ power to the remote reciever interface.
How do I actually do that? I'm a total novice when it comes to TV repair. Would I have to open up the set to test wires with a device, or just the outer switch? One of the wires may very well be the problem, but I have a strong hunch that the problem is with the remote sensor itself. For what it's worth, when the TV was turned off, I took a flashlight and spent a long time looking through the vent holes into the inside of the set where the wires lead to the tuner and sensor. I managed to get a pretty good look at that whole area. It didn't appear that any of the wires were burned or detached. Also, the inside looked remarkably clean for a 24-year-old television. I thought everything would be covered with dust but it wasn't.
Reply With Quote