|
Hello again,
To answer your question, if you have correct voltages on the electron-gun
electrodes, you should get a spot on the screen, but only if HV is present.
Your measurements show positive results, but there are many more things
to check, and because of the distance I cannot think of all of them at once!
In my opinion, the next step would be to measure the cathode voltage
on the 12BQ6 (or 12CU6) horizontal output tube (pin 8). The schematic gives 3.6 V
across the 33-ohm resistor, which corresponds to about 110 mA cathode
current.
It gets hard to go much further without an oscilloscope, but let's see what
you get. Bye for now.
P.S.: for anyone just joining this thread, schematic is in post 56 above. Regards.
P.P.S.: also check voltage on G2 (pin 10) of CRT, this will tell whether the boost
B+ generated by the horizontal ouptut circuit is present. Be careful to use the
highest range on your multimeter.
Last edited by electroking; 09-24-2008 at 03:09 PM.
Reason: added note
|