|
Bryan, I had a loose connection from a wire wrap terminal to the circuit board in a 38, this resulted in no horizontal osc. plate voltage: resoldering the terminal post fixed it. The bad connection was not evident from a visual inspection, but touching the terminal indicated some play in the solder joint...this was confirmed with the voltmeter. You may want to check for this on your set...perhaps a similar condition exists in your chroma area. If it is one one of the screen controls, there is 1040 volts there, so you could get a fairly strong arc.
Last edited by Chad Hauris; 09-17-2004 at 10:57 AM.
|