|
Those selenium rectifiers are probably rated maybe 1/2 amp. Voltage I'm not so sure about though. Probably you'd want something to handle a little more than 200. I used 1N4007's to replace the selenum stacks in my Philco.
PCBs are usually found in oils. THose caps are mostly paper and foil. The electrolytics have some sort of borate in them usually, no PCBs. THe rest are dry (well, other than the water they've sucked up over the last half century)
Handy tip for testing the HV lead. Use one of those compact flourescent lamps or even a small flourescent tube held near the HV wire. If it glows, you have high voltage. Don't get your fingers too close to this, the HV lead probably runs 15,000 volts or so.
__________________
Random bits of stuff in the collection:
Yamaha YP-D4 turntable with B&O MMC 10E cart
Allied 495 receiver
2 Magnavox amps, AMP150 and an AMP178, currently under the knife.
Onkyo TX-4500
Onkyo Radian III speakers
|