|
I think this set uses a tube for the vertical output...I also don't think it has a service switch.
If you have a scope, put it on the grid of the vertical output tube.
(Use isolation transformer on the TV set...it is a hot chassis).
Check for a waveform...if present, the problem is somewhere in the output stage, if not, the oscillator is not running.
Check the vertical height, vertical hold, and linearity controls...there may be a burned spot on a control.
If these do not check out it would be a good idea to get the Photofacts folder.
Last edited by Chad Hauris; 09-09-2004 at 08:26 AM.
|