View Single Post
  #3  
Old 08-20-2008, 01:45 PM
Konrad Schiecke Konrad Schiecke is offline
AK Member
 
Join Date: Jul 2006
Posts: 36
Porthole Designs

Hi Phil, Thanks for your comments.I have 12 sets, mostly 7" ,with round tubes that mask the CRT to a 3X4 aspect ratio. What I was looking for was an insite to what manufacturers did when they shipped a new porthole set. Most manufacturers vertical circuits cannot supply a linear scan to fill a 7" CRT.
I believe that the porthole Bezel was a styling issue. But then again in todays word when you rent a tape which is wide screen (1.85 to 1) or scope(2.35 to 1) a lot of people get mad when they see a black top and bottom on there 3X4 aspect ratio sets. So whats the answer to how porthole sets were shipped ? I did not start my tv design career till about 10 years after the porthole sets came and went. My parents set was not a porthole but a 16" rectangular Sentinel console. So for those folks that had porthole sets when they were growing up what do your memories tell you?
Konrad
.
Reply With Quote