|
There may be a tiny screw located in the center of the anode connector that needs to be removed before the HV lead can be seperated. You can probably salvage a good anode cap from a junk TV or monitor. Some older electronics stores may still have new ones in stock.
The new tripler may or may not come with the HV anode cap attached. Most did; but, some did not. The NTE523 or 526 triplers usually come with the connector attached. I would not replace the tripler unless you see cracks in it's case and/or know it's arcing. Of course, a new tripler may give you better peace of mind. That will have to be your decision. The one for your set will run between $20 and $30. Some parts houses may still have those cheap "no name" jobs for $10 or less. I'd stay away from those. I've purchased too many of those cheap "no name" parts (flybacks, semiconductors, etc.) just to have them bite me in the butt. The NTE, ECG, and SK triplers seem to hold up well.
I've had to replace a few anode caps over the years. Most of them were on '50's and '60's sets where the rubber was rotten.
That gunk around your old HV cap is likely some sort of silicon based material designed to help keep moisture out and reduce arcing. I didn't really see where it was any better than other TV's without this material. I'd probably clean it off before I installed a new anode connector.
You can discharge the CRT by connecting one end of a clip lead to the metal part of a good insulated flat head screwdriver. Connect the other end to the CRT aquadag ground. Now, holding the insulated end of the screwdriver, work the blade under the HV anode cup until you make contact with the anode connection. You will hear a loud pop and see sparks if the tube is fully charged. You can eliminate some of the fanfare if you place a very high ohms (500K ohm or more) resistor in series with the test clip and the aquadag ground.
|