View Single Post
  #6  
Old 06-26-2008, 10:11 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by drh4683 View Post
I noticed that there is quite a bit of corona discharge around the HV lead.
Doug,

Check C278 - GE had a bulletin about this very problem - corona discharge (arcing), too much HV, and short damper tube life. C278 is part of the focus tracking assembly, but can be replaced separately if the two 430K resistors check within tolerance. GE advises to replace the whole assembly if any sign of arcing has occured (carbon traces, bunr marks, etc). Real common problem on these sets.

Two other caveats, based on Dad's handwritten notes - R251, a 39K resistor, will go out of tolerance (high) and cause problems. It ties the horizontal osc/AFC circuit to the damper. Also check C268, a pulse coupling cap (.005uF) that feeds the HV adjust circuit. They tend to open/change value - if it shorts, you'll lose color keying or have color sync issues. Open, no pulse to rectify for HV regulation.

Hope these tips help, still digging. Dummy me passed on the GE service literature from another shop/GE service center that closed after 35+ years. But hey, I DID get the GE parts....

And according to the post office, your resistor has left Norfolk:

Your item was processed and left our NORFOLK, VA 23501 facility on June 25, 2008.


Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote