Thread: Diode question
View Single Post
  #4  
Old 06-15-2008, 08:41 AM
roundscreen roundscreen is offline
VideoKarma Member
 
Join Date: Oct 2003
Location: buffalo ny
Posts: 377
Quote:
Originally Posted by N9ZQA View Post
Hi all -

I think at least one of the diodes in my 1965 Admiral's rectifier bridge has opened up. I was watching the set the other night and suddenly the picture got small and blurry along with a little hum in the audio. Powered it off as quickly as I could and haven't turned it back on except for a few seconds of attempted troubleshooting. It looks like it's indeed running on 1/2 wave instead of full wave - still have sound, brightness, H and V hold do something (but no sync), etc. but it appears as though the B+ is way low.

Anyway, my question is this: The diodes listed in the Sam's are 1N1095 or 1N1696, listed as 500-750PIV, 600-750mA. I've got a whole bunch of 1N4007s laying around (1000PIV,1A). I know the ratings exceed the originals, but are there any caveats to replacing the old diodes with the 1N4007s? I plan on replacing all 4 while I'm in there - if this is indeed the problem. Hopefully will get to crack it open sometime this week...

Thanks!

-Jim
The 1n4007 diode should work fine. Been a long time since I have worked on a admiral set, But if the diodes are mounted on a circuit board, Leave the leads a little longer so the air will get under them and help cool them down.
I have seen diodes open up but think radiotvnut is right, Check all the electrolytic caps. When you get her going again double check the b+ voltage and the horz output tube current.
Ed
Reply With Quote