|
Yow!
You coulda knocked me over with a feather.
I was going over the sound/sync board checking the values of resistors when I noticed what might have been a loose connection. I wasn't sure, as I couldn't find it in the assembly manual. In short, it was a cap with one leg soldered to the PCB and the other one sticking in the air. Near it was a short length of wire, also soldered into the PCB.
What the heck?
Thinking I'd either accomplish something or fry myself, I fired up the set and got the typical horizontal problems. Touched the wire to the cap leg with a pair of insulated pliers. Horizontal locked. Disconnected the connection; no lock. Touched 'em together again; lock.
Woo hoo!
Went ahead and soldered the two together. Actually, it looked like they had been soldered together in the past anyway, so I don't think I did anything dangerous.
Of course, a new problem popped up. Now that I have a steady (if green) picture, I did the grey scale alignment or whatever, and couldn't get any blue. That's odd, 'cause I had plenty of blue a week or so ago when I last did the adjustment. Would a gun just up and die like that? I tried resetting the bias control as the instructions say, but that didn't do a dang thing.
The only other thing I messed with that I can remember is the color killer, but that wouldn't do it, would it? I don't have a tube tester, so I can't check the CRT.
If I can get past this hurdle, then the only things I still need to do are replace the cable between the antenna connectors and the tuner (got sliced somewhere along the line) and finish strengthening the "cabinet" (euphemism for crappyass particle board covered with Con-Tact paper!)
When (when not if !) I get this done, I'll post pics. Figure I'd do the whole beginning-to-end thing.
Onward!
__________________
|