|
Lil' progress
Greetings, Gents:
Well, I've done a little bit of work on my Heathkit, and made a little bit of progress. Not much, but a little.
As per the manual, I replaced the cap it said might be bad, replaced two tubes, checked the value of a resistor (it was good) and replaced the dual diode. Also tried adjusting the horizontal something coil--oscillator? efficiency? Think it was oscillator.
Anyway, with careful adjusting of the horizontal hold control, I can get a pic to stand still for a couple of seconds, but after that, it starts scrolling sideways again. Doesn't really turn into diagonal lines, the whole picture starts flying sideways. I can get it back again (temporarily), but it requires very careful adjusting of the HH control. Like a millimeter too much is enough to send it scrolling again.
Any ideas what I should check next?
The picture is still green, though I reset the grey scale (?) which brought in nice black & white for a while. Now it's back to green, but I'm not going to worry about that until after I can get the picture to stay where it oughta be!
Not gonna post any pictures until I've made enough progress to make it look presentable!
__________________
|