|
First I want to thank everyone who helped me on this set....Bill R you were very patient and very helpfull, all of you were a great source of knowledge....i think you can see where im going with this....as Bill correctly led me to diagnose...the low level video detector IC was bad. Replacing the IC brought back a full color picture....heres the details:
today in the mail came a box from prelco electronics, i gleefully opened it like a kid on christmass and found 1 IC-my low level video detector. i was happy to see it looked the same (you never know these days with internet electronics supply places). i removed the offending IC from the TV and popped in the new one. threw the cord on and figured id see what i get before i put the cord back into the back of the set and clip it in place and put the shields back on and whatnot inscase it didnt work. i turned on the power and waited....and waited....and finally....dimly....i got SNOW!! I immediatly shut the TV off and put it togeather fully, and buttoned it up, hooked it to the VCR and tried to get a picture for the first time in over 2 weeks. I had dim picture. twiddling the contrast and brightness controlls helped but the picture kept cutting out....i found the brightness controll was causing this so off with the back again (im getting good at this) and found that when i slid the back on i must have hit the brightness knob and cracked one of the solder joints....no worries ill solder it....well not tonite since my only soldering gun is at work (booo). So i couldnt get a picture of it in action BUT it IS in action...or will be fully tomorrow afternoon....when i held the brightness knob i got a perfect (same as always on this set) picture!!!! I really cant believe i fixed it....im so happy!!!! it cost me 8 bux after shipping.
Below is a picture of the blown video detector IC. tomorrow ill post pix of the set doing its thing again once i reflow the solder on that brightness pot.
|