View Single Post
  #2  
Old 05-07-2008, 05:24 PM
Tugboat Tugboat is offline
Banned
 
Join Date: Apr 2008
Posts: 40
Okay, got the CRT tester today and I downloaded the general instructions for it from B&K. The CRT tested fine and installing the new video output board brought the set back to life.

I have the service manual (PDF) for the set, but it sure doesn't make things easier. It figured out that U8 mentioned in the manual was a connection on the sync. A.C.G. board and that when it's grounded, the show goes away and I can then set the brightness limiter and range controls. I was also able to set the G2 control to produce a dim raster. But that's as far as I was able to go/figure out.

The set produces a decent color picture with just the G2 set. The red, green and blue controls on the board are at their minimum settings. What am I supposed to do with these adjusters? I must need to do something with them or why else would they be there.

My brother says there should be a "setup" switch, jumper or something like that. The manual keeps referring to G2 and color controls...turning down all, then turning one up to get a raster of that color gun in the center of the screen and check for it being uniformed across the screen, blah, blah, blah. When I turn one of the color controls, the snow on the screen starts to take on that color. The manual doesn't say I should ground U8 for this adjustment, so how do I get rid of the snow and get to the raster?

Don't mean to babble so much, but I'm a bit confused at the moment.

Thanks!
Reply With Quote