View Single Post
  #18  
Old 04-30-2008, 11:03 PM
Bill R Bill R is offline
VideoKarma Member
 
Join Date: Oct 2004
Location: Jackson, TN
Posts: 893
You will see some form of video on pin 2, as well as pin 3. Pin 7 is the input, 1 is the output to the sound circuits, and pin 4 is the output to the video circuits. Keep in mind that the signal on pin 7 is before the audio take off and before the video detector stage, so the waveform will be an IF waveform, but it will be there. Since you said you have audio, you should have signal at pin 7. Pin 2 and 3 are the 45.75 mhz tuned circuit for the video detector stage of the IC. Be sure to touch carefully touch up the solder connections to the IC, as they can cause problems. Using a vcr is not that crude, but the output from the vcr is composite video so injecting at pin 7 probably will not work. You could use it to check after the IC as you have done. There would be an impedence mismatch, but with a pad to attenuate the signal and a coupling capacitor to isolate it from the DC in the set it could work. I wouldn't expect a perfect picture, but any picture would indicate that the video path was working from that point. The Sylvania part number for the IC is 13-39060-1. It will probably cross to an NTE/ECG replacement.

Bill R
Reply With Quote