View Single Post
  #8  
Old 04-27-2008, 11:28 AM
Keefla Keefla is offline
VideoKarma Member
 
Join Date: Dec 2004
Posts: 192
Quote:
Originally Posted by Bill R View Post
That should be an E21 chassis. Check the service switch. Switch it back and forth a few times. All video passes through this switch, and dirty contacts can cause you to loose the video. Back from the switch is the video amp transistor Q904 (I think), it will cause no video as would the failure of the video buffer transistor Q902 (I think). If you have sound then everything up to the sound take off should be ok. This leaves the switch, about 3 transistors, and the low level IC for processing the video. As always 30 year old caps and out of tolerance resistors can kill a transistor, or IC, and bad solder joints in this area could be a problem. There isn't much on the neck board as you noticed other than some biasing resistors.

Bill R
Bill, thanks for the suggeations. it is an e21 chasses, and according to the transistor layout sheet inside the set it lists Q904 as the video driver and Q902 as the video amp (so you were on target just backwards....i say thats close enough for probably not having seen one for 20 years!). So i will remove and test them. I did try the service switch and it seems fine, i saw no hint of video when switching it back and forth, even hit it with some contact spray just to be sure. ill post back as soon as i test the transistors and let you know.
Reply With Quote