View Single Post
  #3  
Old 04-13-2008, 06:39 PM
jpdylon's Avatar
jpdylon jpdylon is offline
<-- sucker for old sets.
 
Join Date: Apr 2005
Location: Knox County, Tennessee
Posts: 1,675
I'm hoping that the problem isn't in the yoke.

I'm going to go over the vertical sweep with a fine tooth comb this week to see if I can find anything I may have missed earlier.

I didn't think of the convergence assembly. Could a fault there really cause that kind of problem? Is there a way I can operate the set without the convergence board in circuit as a quick way to see if that is the problem?
__________________
Jordan
Reply With Quote