View Single Post
  #54  
Old 07-07-2004, 11:29 AM
mbates14 mbates14 is offline
VideoKarma Member
 
Join Date: Apr 2004
Posts: 1,016
Steve K told me that the reason I dont have a vertical linerity control, because each plate has the exact same waveform, but its inverse from each other, and for some reason its not the same on mine.

No, I dont have ceramic caps on the vertical stage. just the horizontal stage.

I have big brown caps on the vertical stage. There old, they were already in the set, and they test fine with no leakage. So, I used them. I dont have the money to purchase anything from allied, and they can shove that minimum fee up thier a**.

First, I thought one of those are bad, but I removed each one from circuit, and left the other in. Vice Versa, they both affected the picture when either one was removed. If i remove them both, there isnt any sweep.

So the caps are good, and I did a capacitor check on them through my DMM, and they test alright. There isnt any leakage.

Last edited by mbates14; 07-07-2004 at 11:34 AM.
Reply With Quote