Thread: Beltron Bulbs?
View Single Post
  #7  
Old 04-03-2008, 04:07 PM
kbmuri's Avatar
kbmuri kbmuri is offline
VideoKarma Member
 
Join Date: May 2006
Location: Fort Wayne, IN
Posts: 590
The indicator lamps in the Beltron CRT Restorer serve two purposes. The obvious purpose is to provide the operator some visual indication of what's going on. The not-so-obvious purpose of the lamps is to act as fuses to protect the meters and internal components (and the customer's CRT) from overcurrent. The lamps are designed to be the weakest link. This is why most of the used Beltrons for sale have burned out bulbs in them.

The two Restore Lamps do limit current to some degree, but not to the degree necessary to prevent damage to the tube. The "current limiter" for the restoration process is the person operating the equipment. When you first apply restoring current to the tube, the lights are not lit, and the meter reads zero or very low. Over the course of a couple of seconds, the meter rises and the lamps slowly increase in brilliance. What's going on in the tube at this point is things are ionizing between the grid and cathode and as more ions occur, more current flows, causing more ions to occur, causing more current to flow... It feeds on itself exponentially. This is the beauty of the Beltron process vs. other CRT rejuvenators. You don't just blast a fixed current through the tube and blow away half the cathode's chemicals. You softly build up the current until the tube itself tells you it's had just the right amount, and then you stop. This is why the Beltron is so successful at restoring picture tubes.

So like I said, the current limiter is the operator. It's his job to watch the meter and lamps and hit the cutoff switch at the appropriate moment (when the lamps reach a brightness level and the meter reads 85). When the meter drops to a certain level (65), he repeats the process once or twice to make sure the cathode is completely clean. Any more times than that is overkill and could strip the cathode unnecessarily of it's ion-producing chemicals.

So long story short, if you took one lamp out, you might limit the current to a certain degree, but the result would be that the exponential-curve rise of the meter would just take longer to reach 85. But more than likely the single bulb, taking the current load meant for two bulbs, would just burn out first. This is the Beltron's failsafe so that you don't smoke the customer's picture tube (as a serviceman in the field) by goofing up and looking at the wrong meter, or by being distracted by the pretty customer.

I haven't actually tried it, but that's my theory. They put two bulbs in for a reason, and I'm sure the engineers balanced everything correctly when they designed it. Pulling one bulb would be a mistake. My 2 cents.
Reply With Quote