|
Your computer based receiver card and software may do some stupid things with channel numbers. A regular digital TV should be designed to show the channel number of the analog signal plus a secondary number after a decimal point or dash. Thus, analog channel 20 (which is really on RF channel 20!) should show as simply "20" while all the digital signals put out by that station (whcih are on a different RF channel) will show as 20.1, 20.2, 20.3, etc. One warning - this does depend on the station sending out the correct designation, but they should all straightened out on this by now! The broadcasters (at least the ones who were paying attention) insisted on this arrangement because their local programming is usually branded by their analog channel number, e.g. "TV7 news at 11:00."
An exception to this may occur during intial setup - the set may use the actual RF channel number until it has acquired the "virtual channel number" form the DTV broadcast.
Regarding indoor antennas, the loop is not so great. There is a small log periodic called the "Silver Sensor" and some other variations on it that is pretty good, and surprisingly, the old "dual bow tie and reflector" set top is not too terrible either for UHF. Indoor low VHF can still be a problem for digital as it has been for analog, but in your case, if all the digital stations are UHF, no need to worry. An amplified indoor antenna may or may not help - unfortunately their designs seem to vary all over the place.
|