View Single Post
  #3  
Old 02-02-2008, 10:30 AM
dr.ido's Avatar
dr.ido dr.ido is offline
VideoKarma Member
 
Join Date: Mar 2005
Location: SE Melbourne, Australia
Posts: 550
Well it's inside now and the chassis is out. Most of the connections are terminated with individual push on terminals or screwed in terminal blocks, but I hope I took enough pictures to get everything back where it should be.

That TV chassis is all tube with the exception of a few diodes. It has it's own tube audio stage, so the transistor audio amp is only used for the changer. The hanging wires appear to be from the TV power switch which also switches the speaker from the TV/changer.

Other than lots of baked on dust and some minor surface rust the chassis looks OK. There is some black soot around the 1S2 EHT rectifier, but the flyback itself shows no obvious signs of cooking. What's the best way to remove 40 years of crud without doing any damage? This stuff isn't moving with a dry brush.

There aren't many paper capacitors that I can see. Most of the capacitors appear to be Ducon polyester and Simplex foil.



Are these likely to be still good? At least for initial tests? I will replace the electros and paper caps first, but I was hoping to be able to verify the CRT and flyback are good before doing a full recap.

Tonight I was offered the guts from an old Thorn console set (supposedly working) that someone wants to turn into a fishtank. From memory many of these sets used very similar chassis regardless of brand, so I should have some spare tubes and possibly a flyback/CRT.
Reply With Quote