View Single Post
  #10  
Old 12-17-2007, 12:51 AM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
Still no HV could be caused by a bad 9-90 horizontal module, the small horizontal driver transformer, or the tripler. The horizontal driver transformer should read around 96 ohms between the blue and red wire and about .3 ohms between the yellow and black. There should also be around 79 volts DC on the red wire. If this voltage is absent, check RX222 (800 ohm, 10 watt resistor) for an open condition. There should be 21.8 VDC B+ at point U4 on the horizontal module. This can also be measured at R815 (620 ohm, 1 watt) located on the horiz. module. The best thing would be to find a good horiz. driver module and swap it. I don't currently have one; but, I'm sure someone on here does. Like I sais earlier, I remember changing the cap and resistor and also having to change the horiz. module to get HV back.

Usually, when the tripler fails, it either cracks open and burns or shorts and trips the circuit breaker. The best way to check it is to unsolder the black wire coming from the flyback to the tripler. You'll have to remove the RTV that covers the terminal first. With the wire unsoldered and moved out of the way of the chassis or any other parts, turn the set on and see if you can hear a slight sizzle, see a blue spark, or smell ozone. I have also taken a screwdriver and drew an arc from the lead to the screwdriver. If there is HV there, the tripler is bad. I have also seen the triplers short in these sets and take the flyback with it; but, that has always resulted in a tripping circuit breaker and the flyback getting warm, even with the tripler unsoldered.
Reply With Quote
Audiokarma