View Single Post
  #9  
Old 12-05-2007, 11:26 PM
Chad Hauris's Avatar
Chad Hauris Chad Hauris is offline
VideoKarma Member
 
Join Date: May 2003
Location: West Texas
Posts: 2,085
Andy, did you measure that voltage across the new test resistor with a digital multimeter?
I tried using a digital multimeter in the milliammeter mode to measure current directly in the cathode circuit (without the resistor) and connected the .1 cap across it but the reading would fluctuate all over the place.
The last couple of times I did it, I used a 6 volt light bulb in the cathode and adjusted the efficiency coil for minimum brightness. Would be nice to get a good reading on a digital meter though.
__________________
Chad Hauris
http://www.youtube.com/user/retrochad
Reply With Quote