Quote:
Originally Posted by rcaman
hi again, youre gonna have to put some grunt into removing those wires. just jet you a pair of pliers and yank them out. there not like most that you have to push in and turn to remove. and when you install the new splitter you can feel when the wire seats back in the new splitter. steve
|
So, will I see a bare wire end, or a connector, or what? And I can just push the leads into the new splitter and that's it? Sounds easier than I expected!

EDIT: I was able to remove the splitter.

The bare cable ends look like needles. I marked each lead with a Sharpie so I wouldn't mix them up, just in case.
Also, is it this resistor
http://www.tritronicsinc.com/storefr...79&itm_index=5
and which of these three choices should I go with?
http://www.tritronicsinc.com/storefr...68&itm_index=0
http://www.tritronicsinc.com/storefr...23&itm_index=1
http://www.tritronicsinc.com/storefr...73&itm_index=2
Also also, after I was told to look for R14718 and 719 to be bad, I looked and found 718 blown. 719 looks good still, I'll check it with the trusty DMM.

EDIT: R14719 is still intact. Oddly, 718 reads as still closed, but because it's burnt. I'm replacing it anyway. It sure as heck is a good thing 719 is good, because Tritronics discontinued them!