Quote:
Originally Posted by Adam
but I wonder if it could be done with the old fashioned components we're all used to: tubes, caps, coils and such things, even if the converter had to be the size of a big tv-radio-phono combo set.
|
In a word, no. The demodulator part can be squeezed into about a 1.5 to 4.5 inch high rack mount chassis using the latest FPGA (field programmable gate array) chips. The huge number of transistors (logic gates) are needed for the adaptive equalizer, since the digital signal must have all "ghosts" cancelled before the signal can be demodulated. At that point, you have a stream of digital bytes (MPEG Transport Packets), and you need an even more huge number of transistors to do the motion-compensated decoding of the MPEG bit reduction algorithms.
So, your closest hope would be to do a multi-layer PC board using the custom chips that have been designed for these tasks. What originally filled a series of a dozen or so 19-inch-wide by 6 foot tall racks in the early 90s now is on 3 or 2 or even 1 custom chips in a digital TV. The "Digital Terrestrial Converter Boxes" that qualify for the government $40 coupon will probably all have a single "system on a chip (SOC)" that takes the IF from the tuner and goes all the way to composite video and stereo audio for your old TV.
You could conceivably design at home a tuner system (RF, mixer and perhaps IF stages) to feed the above-mentioned digital stuff, but you still might have some difficulty if the SOC needs some particular interfacing.