|
It would be very difficult to swap out the IF from a turret tuner into a digital stb (set-top box), without being a software engineer to rewrite the STB's firmware. A daunting task to say the least.
The ATSC digital signal has a program table that the stb firmware alias back to a specific frequency for the needed stream where it expects the "program" to be (ie CH 14.1, 14.2, etc. are "programs" on the stream). These are determined when the stb does a search of available stations (streams).
When you choose an ATSC program to watch, the stb's processor sets up the RF tuner to present the demodulation hardware the required stream, then the processor sets the demodulator to decode the correct program on the stream. There are a number of parameters passed to the demodulator, including screen resolution, audio and video program ID's etc.
Without this, there would need to be at least two actions to change the "channel" -that is, select a program. One would be to select the correct "turret" tuner's setting to present the stb the correct stream (ie select whatever RF channel the ATSC channel would be on), and then you would have to select the correct "program".
This assumes that the tuner you're attempting to interface to is stable enough for the 8VSB signal.
|