View Single Post
  #4  
Old 11-07-2007, 11:55 PM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
I am no big screen expert by no means; but, I'll share a recent experience of mine. I got "roped in" to fixing someone's Akai (Samsung) 42" that would fire up and go into shutdown. One of the STK convergence IC's was shorted. To be safe, I replaced both of them and the set now had a picture but the blue convergence was way off. It was much better in the center than around the edges. I found that I could adjust the blue vertical lines; but, not the blue horizontal lines. The red lines would adjust as they should. I noticed that there was a mess load of 3.9 ohm, 1/2 watt fusible resistors on the convergence board (board with the STK's). I found two 3.9 ohm resistors in parallel that were both open. They checked open on the board; but, read 10 ohms and 19 ohms when removed. I guess the heat of the soldering iron must have made them fuse back together. Anyway, two new 3.9 ohm resistors and two STK's solved the convergence problem.
Reply With Quote