View Single Post
  #8  
Old 10-26-2007, 08:31 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by Geoff Bourquin View Post
As long as I'm rambling on and on, Ill make a comment on the heat sinks. Some of them don't use the white grease, but use those rubbery "sil-pads". I always remove them, and use the white heat sink compound. Here's why: I studied how some of those are assembled, and found that often the sil-pad does not make good contact with the heat sink and/or the IC. It seems that when the screws are snugged down something warps a tiny bit, and the contact to the heat sink is poor. The grease will flow into the gaps and fill that space, giving better heat transfer.
Amen! When I was in the Navy, we had an airborne IFF transmitter section that used Sil-Pads. We always had really low reliability on these, so a few of us tried using Heat Sink Compound on a couple of transmitters, and we tracked the serial numbers. Bingo! No more failures of the regulators. One did come back for repair, but only because of over-torquing/breaking of some captive bolts. Regulator(s) were fine!

Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote