View Single Post
  #36  
Old 10-09-2007, 06:20 PM
karmaman's Avatar
karmaman karmaman is offline
AK Member
 
Join Date: Mar 2007
Location: Escondido, CA
Posts: 137
I think my multimeter is useless, it was really cheap ($4 from Harbor Freight), and whenever I measure any of the three caps I pulled from the TV, I get 0.2 or 0.1, on all three caps. The caps are a 1000uf, a 220uf, and a 200uf. When I measure the 100uf with the multimeter on 200uf, I get 0. When I measure a 220uf with the multimeter, I get 0,and a 1000uf cap reads 0. These are all caps I replaced in the TV, but there was no change in the overscanning after swapping them out and since there were three, I figure at least one of them must have been OK.

Bad multimeter or bad caps?
Reply With Quote