|
The channel number will be in the window to the left of the UHF tuning knob. The UHF knob is the large knob under the open door. Almost all Zenith sets with remote control will not have VHF tuning knobs on the front panel they will use the power tuning having a button for higher and lower. If the set is a lower end set it may have only have tuning in the higher direction. As Doug has pointed out there is a knob in the rear of the tuner on the back of the set that was to be used to set the channel skip tabs on the rear of the tuner. They were used to skip over unused channels in the owners local area. It became handy when the tuning motor would fail later in the sets life.
|