|
You can only get one line? Screens and drives are two different things. You should have 3 screens, one for each color. There is only a green and a blue drive, because the red drive is run wide open by default.
Ok, If you start with the drives all the way up, and the screens all the way down, you can only get a green line by bringing the screens up? Even with the kine bias set all the way up?
If so, that sounds like a weak tube..... but... don't give up yet if that's the case. The first thing to try when you get that crt tester, is to run the filament voltage a little high, maybe 8 volts or something, and let it cook a little while. The emission will probably come back.
There could also be chassis problems causing it not to track, but the CRT tester should tell the story about the tube.
John
P.S. Maximum contrast (and thus brightness) is limited by the efficiency of the weakest phosphor, and the high voltage regulation. Emission has less effect, unless its really horrible. The odds are in your favor.
.
|