View Single Post
  #12  
Old 09-29-2007, 03:34 PM
Tube TV's Avatar
Tube TV Tube TV is offline
VideoKarma Member
 
Join Date: Sep 2007
Location: At large again ....
Posts: 788
I had the same problem , I bypassed the seleniums and put in diodes and had the same problem . I had salvaged them out of a stereo . It turned out that one was connected wrong , seleniums are hard to find info on and I fried one diode . I didnt have the schematics for the set .


The 6EA8 should be fine . my tube checker is a sencore mighty mite and it does this sometimes and it will also have the wrong grid leakage readings when the humidity is high .

the vertical hum , is it strong or weak , check the controls for vert size , vert line ect. and see it they are changing in ohms , you may have to remove the wires on them to do this . I would also look through the resistors especially anything from the power to the vert circuit . something in there might weak in there. If you have the schematic check the voltages in the set and see if there is somthing running low .
when you done the recap , did you do the filters?

If I was going to put my finger on the problem I would say it was in the power supply .

Is the remote system tube or transistor ?
Is is switched on with a relay ? of does it only change channels
I doubt that it is in there .

will the TV pick up stations at all ?
Reply With Quote