View Single Post
  #28  
Old 09-15-2007, 04:48 PM
RaymondLeggs RaymondLeggs is offline
Banned
 
Join Date: Aug 2007
Location: Owensboro, Kentucky.
Posts: 31
Quote:
Originally Posted by roundscreen View Post
Thank you. The motorola has been a problem child, After running it about 20 hours it started having 2 white bars moving up from the bottom to the top of the screen.
I went and replaced all the electrolytics in the power supply and on the main chassis. And still, It did not correct the problem. After that I recaped and replaced all the panels in the set and Still it had the bars in the picture.
Then I got out the oscilloscope, Took a look at all the power supply voltages lines and could not see any ac in them.
When I went and took a look at the video signal you could see the bars running in the video signal. It was a strange picture on the scope, Kinda looked like a snake as it made its way through the video signal.
What I found was I had two leaky transistors on both of the video,agc panels I had replaced. After replacing the leaky transistors with nos transistors, The problem went away.
I had made the comment that the crt was crap, But I was wrong. This tv really has a nice clear picture. When I get the time I will remove the safety glass on the crt, Clean off the glue, And reinstall the glass to get rid of the yellow edges.

The problem with your crt falling back could be one of the mounts holding the crt in place is broken. Also I have seen sets where someone replace the crt and did not tighten the screws that hold the mounts to the inside of the bezel. If you take a close look at the crt from the back side with a flash light you should be able to see what is wrong. PLEASE be careful when working with a crt. It could go boom boom and hurt you.
What kind of set do you have and how old is it? Have you done repairs on vintage tvs before?
Ed
No I havnt done any real repairs on anything before. But I did see an old Zenith TV in my grandmothers house that has that problem.. It's probably just junk but I am curious!

But I did replace the tinny speaker in a toy keyboard once! sounds a lot better now
Reply With Quote