View Single Post
  #8  
Old 09-08-2007, 09:01 PM
PioneerGuy75's Avatar
PioneerGuy75 PioneerGuy75 is offline
Pioneer Memeber
 
Join Date: Sep 2006
Location: Denver, Colorado
Posts: 58
Quote:
Originally Posted by Geoff Bourquin View Post
I'm going to guess it is in the module in the middle of the signal board, About 6 inches long and an inch thick, enclosed in a metal case. There are some surface mount electrolytics in there that are probably bad. (4 of them I think).
Unsolder this module and remove it from the signal board, then open it up and replace these 4 caps. I usually just use a good quality radial lead cap rather than putting in new surface mount jobs. There is enough room if you are patient.
I hope I'm thinking of the same chassis as you are.
Thanks Geoff

Well, now I am in DEEP.....I took comb filter module out, opened it up but don't recognize the caps you are talking about. If they are the "little metal cans" with a black stripe on one side (These are the closest cap looking components on here.), I count 20

How do I determine the value of these and more importantly, where would I get replacements ?


Thanks so much for your help, I am pretty familiar with electronic stuff but this is like "Micro-Surgery"


Thanks again for your assistance and hope to hear back soon.
Reply With Quote