Thank you. Much appreciated.
The popping sounds you heard were likely caused by a combination of bad capacitors, and shorted filters..
No. You will need to put all new electrolytics in it as well. Take special note that there are a number of 1600 volt caps in it, and you will need to use that high a rating, also.These are in critical circuits with high pulse. Some of these are on the sub chassis in hv cage.
I personally get totally rid of the line bypass caps, and resistor, as well, as this causes a shock hazzard. I would reccommend in investing in a good 10A variac. There are mica capsused in the video IF, and, horiz. oscilator, and output stages of this set. They may be bad, also. The deflection youkes were prone to shorting out in the KCS 47 sets. You can still find a good replacement with some searching.
I would highly reccommend against plugging this set in this way again until properly re built. You could do great dammage, and , possibly injure yourself, or, conceivably burn down your house.
When all these precautions are properly done, I guarantee that as long as your picture tube is still good, they have years of life, good brightness, and great contrast.
By the way, besides for the obvious reasons, NEVER use a metal screwdriver to adjust tuner oscilator screws! They put high B+ on them! In this case about 370 volts!
The bell of the picture tube is where the hv is, so NEVER come in contact with it while the set is on, and Be sure to completely, safely discharge the high voltage before any handling.
Sorry. I live in St. Petersburg, Fl., otherwiise, I'd be happy to help. I could re build the chassis, but, you would have to ship it to me.....
Hope this helps some....
Very nice set. I have a couple of this model, but, not in this nice a condition...
Bill Cahill