|
Several parts distributors used to sell the kits of most-commonly failed parts for these. These were shotgun affairs - basically all of the caps and a few other parts. Andy is dead on - high ESR is the killer of these power supplies.
I was unable to find one for the VEP01617A, but MAT Electronics (no connection/affiliation, but I have purchsed from them before) has two oother VEP kits listed:
Panasonic Type VEPS0167 SMPS Repair Kit
- PROVIDES THE NECESSARY COMPONENTS TO REPAIR 95% OF ALL FAILURES IN THE SWITCH MODE POWER SUPPLY.
- CONTAINS: (1) 1.6A GMA FUSE, (1) DB104 BRIDGE RECTIFIER, (1) EG01 DIODE, (1) 2SC4130, (1) 2SB643, (1) MA165 DIODE, (1) MA130 DIODE, (1) TLP621 OPTO ISOLATOR, (1) 82uF/200V, (1) 1uF/50V, (2) 330uF/6.3V, (1) 6.2V, 1/2W ZENER DIODE
= And =
Panasonic Type VEP0172 SMPS Repair Kit
- PROVIDES THE NECESSARY COMPONENTS TO REPAIR 95% OF ALL FAILURES IN THE SWITCH MODE POWER SUPPLY.
- CONTAINS: (1) 1.6A GMA, (1) DB104 BRIDGE RECTIFIER, (1) EG01 DIODE, (1) 2SC4073, (1) 2SD1458, (2) MA165 DIODES, (1) TLP621 OPTO ISOLATOR, (1) 1uF/50V, (2) 330uF/6.3V, (1) 82uF/200V, (2) 330uF/16V
Your mileage may vary, but I've shotgunned the listed parts and fixed a few - most of these were junked due to the lower cost in replacing them.
Hope this helps -
Cheers
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"
When fuses go to work, they quit!
|