|
When I joined Motorola out of school in 1966, they were starting to produce the all solid state chassis with "works in a drawer", including the HV rectifier. It was the most expensive not only because of solid state, but because of all the wiring to connect many small modules. The later retreat to a hybrid chassis also involved using fewer and larger modules, if I recall correctly.
The Motorola rectifier in bgadow's post is one variation on shape for this type. The rectifier consists of a stack of dozens of low-voltage rectifier chips. Since there is capacitive current in each diode, the chip at the bottom would see all the capacitive current and blow out, if not for the flared shape of the package, which provides a capacitive path bypassing the chips near the bottom. Some models have a sort of exponentially flared pair of fins on the sides of the stack - providing some cooling as well as capacitive bypass. Varo semiconductor was one of the suppliers. Later solid state designs could use high-voltage solid state rectifiers, although they usually needed more than one in series. Some later designs used, say, three diodes, placed in between three flyback coil sections in series, and all potted into the flyback. This helps equalize the transient voltages and currents.
|