View Single Post
  #55  
Old 06-28-2007, 09:25 AM
Radiophile2001's Avatar
Radiophile2001 Radiophile2001 is offline
VideoKarma Member
 
Join Date: Jun 2006
Location: Montclair, VA
Posts: 105
Quote:
Originally Posted by Chad Hauris View Post
Yes, the 12HG7 is a 9-pin miniature base
(the larger 9-pin like used on the 6JE6 output tube is called a Novar base)

I would double check the socket...if it is not burned and is in one piece it is likely OK...more often the problem is microcracks in the solder attaching the socket to the board if the tube appears intermittent.


Thanks, both of you, for the info......yep, I had re-soldered all of the socket connections before to be sure that wasn't the problem....Now when I stick the tube in, there is a little bit of sparking going on with one of the pins.....the plastic is cracked and getting brittle.....does this seem like a socket issue itself now?

I remember when I put the new tube in that socket (along with all new other tubes) it performed like new for a few days. I think I had been maximizing all of the settings and making sure all the new tubes were fully in their socket and then the problems started. Had to jigger the 12HG7 just right for the set to work, then it just kept getting harder to "find that just-right position"....Then it just lost the picture and sound altogether. Now I have a dimly lit screen with no sound or reception--ironically just as it was before I replaced all the tubes....!

Any theories would be greatly appreciated......as I am an amateur in comparison to the AK mindtrust.

thanks
Reply With Quote
Audiokarma