View Single Post
  #17  
Old 02-17-2004, 10:20 PM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
Max,

are you absolutely sure it goes through to the coil?
If it does you should be able to turn it continously for quite a few turns in each direction. There may be a stop inside that metal bracket. not suggesting you should force it or anything

If you could turn it more than 3/4 of a turn you might be able to lock it in on frequency.

chances are something like a cap or resistor has drifted off spec to mess it up in the first place but you might be able to compensate with the control.

Quote:
Originally posted by maxm
Hello,

The Horizontal hold is actually a coil, it looks like a pot because is is mounted along two other pots, but it goes through that piece and into a coil. The problem with this set is that there seems to be no other hozizontal contorl coil on the chassis, perhaps something that was eliminated on a small set like this to save cost??

Thanks for the help,
Max M.
Reply With Quote