View Single Post
  #5  
Old 06-16-2007, 11:05 AM
roundscreen roundscreen is offline
VideoKarma Member
 
Join Date: Oct 2003
Location: buffalo ny
Posts: 377
One way to soft start your 2000 is the light bulb. Connect a 60 watt light bulb in series to hot side of the ac cord. Disconnect the deguss coil and put a jumper on the on-off relay,{ pins 2 and 5}. Turn on the master power switch and Plug it in the wall. If you are in a quiet room you should be able to hear the high voltage and sound start up and the bulb should be dim. Check the B+ and stand by voltages too. They will be lower than normal but a good clue that the set will power up at full voltage .
Warning.... When you check the electrolytic caps at full voltage with your meter, Make sure you remove them out of the circuit first.
DO NOT... Move, Jiggle or remove any plugs or boards when the set is running.
The best way I can put is if you look at the transistors the wrong way, They will short. When you recap the set check for bad connections on all the boards and burned resistors too.
It will be cool to see your set running, The 2000 has a really good picture.
Ed
Reply With Quote
Audiokarma