View Single Post
  #13  
Old 06-10-2007, 02:09 PM
kx250rider's Avatar
kx250rider kx250rider is offline
REAL TVs have TUBES!
 
Join Date: Oct 2005
Location: Los Angeles & Dallas
Posts: 3,239
Definitely look at that oval, oil-filled cap, which may be bulging on the top where the 2 terms are. Measure the 24-volt regulator transistor (in a socket near the breaker) for short. Next measure from the case of the Horizontal Output #121-831 transistor on the big heat sink at the top Rt of the chassis as you look at it from behind) to ground, and be sure it isn't shorted. If so, remove it and see if the breaker still pops. If not, you probably just need to go get an NTE-165 and replace it. If the transistor is not shorted, and if the oil-filled cap is OK, then next try the HV tripler. All you have to do to check that is to remove the blob of silicone that covers the terminal on the tripler where the wire from the flyback goes. Unsolder the wire, and pull it at least an inch away from any metal. Try the set, and see if the breaker still pops. If not, you need a new tripler. Obviously, there are other things that cause the breaker to pop, but these are the most common, and I worked on plenty of those.

Charles
__________________
Collecting & restoring TVs in Los Angeles since age 10
Reply With Quote