View Single Post
  #9  
Old 05-28-2007, 09:24 PM
compucat's Avatar
compucat compucat is offline
1949 Motorola 9VT1
 
Join Date: Apr 2005
Location: Suffolk, VA
Posts: 970
I got the cabinet back and assembled the set. It works!

I do have a question regarding setup. I completed all the procedures and got it looking great. Later I moved the set to where it will reside so I could give it a good run-in before I put the back and bottom covers on. In the new location, I noticed the purity was off. I corrected it only to have the convergence settings change. I have never seen a set so location sensitive. Modern sets, especially portables don't have this problem. Can anyone tell me what it is about these early sets that makes them this way? Or what is it about newer sets that makes them more immune to location changes?

So far, I'm quite pleased with this set. It has turned out well. I suspect I still need a couple of tubes because when it is first turned on, the picture flashes and the brightness changes. Tapping the video output tube seems to aggravate the condition. Once it has been on for a while, it is steady. Occasionally the vertical will slightly shrink for a split second also.

Here are a few pictures. The cabinet restoration came out well. I added threaded inserts to the screw holes where the bottom plate attaches and where the front cross brace (not shown) attaches. It works great off the ATSC tuner as well as DVD except the copy protection put lines in the top of the picture. Any way to get rid of these?

I feel like I have finally joined the roundie club.
Attached Images
File Type: jpg PDR_0436.JPG (124.7 KB, 60 views)
File Type: jpg PDR_0439.JPG (114.5 KB, 62 views)
File Type: jpg PDR_0441.JPG (120.2 KB, 55 views)
File Type: jpg PDR_0442.JPG (121.4 KB, 61 views)
__________________
Just look at those channels whiz on by. - Fred Sanford
Reply With Quote