|
have you unloaded the 5 volts to the tuner. i use solderwick then see if your 5 volts come up. also a bad 5 volt regulator i.c. or a electrolytic cap in the 5 volt supply can be bad and the voltage come up when you unload the supply have seen it many times. the regulator is bad but it can regulate the 5 volt line without a load. also check what voltage you have going into the regulator it may be low it should be around 9 volts or so going into the regulator. this will be a 3 leg stand up i.c and may have a heatsink on it. mitsu. has had a ton of capacitor problems you can also look at the negetive leg of the caps and see if they are green or turning or have turned dark. another way is to put your soldering iron on the board side negetive lead of cap and add a drop of solder and it it stinks it is bad. some people say it smells like fish but to me it smells like a dirty public bathroom.(piss) i reoaired a mitsu. big screen a few months back and i replaced about 70 capacitors in it. reg ic
pin1 +9v>in____pin3 5v>out
pin2 ground
|