View Single Post
  #26  
Old 04-26-2007, 05:03 PM
drh4683's Avatar
drh4683 drh4683 is offline
VideoKarma Member
 
Join Date: Jan 2003
Location: Chicago, IL
Posts: 2,094
Motorola Update!

I have the Motorola up and working! Took the bezel off to clean it and cleaned and polished the cabinet. It looks very nice now. The set had a good 1/8"-3/16" blanket of dust inside the cabinet. Had to pull the chassis to clean it. As you can see, there is hardly any clearance to get a vacuum in there with a brush. Hard to get at the tubes too. Having the chassis pulled made it all easier. In fact, I think im the first to have pulled the chassis. All of the original wire straps were still neatly in position (which they were all returned during reassembly). It’s a very nice looking flyback, original. Has a soft silicone like tire that is not deteriorating. Had some bad tubes in the color circuit. Also had a weak CRT. Raised the heater voltage for about 10 minutes and that helped very much. The cathodes came back quite well, even at cold start up, the color temperature is excellent and bright.
This chassis uses a hand full of the 6BL8 tubes which l had plenty of. Has a color program indicator (that orange neon bulb on the lower left of the control escutcheon).
Focus pot opened up. It’s a 10 meg carbon pot. Didn’t have anything like it, but found a 4.7 meg resistor to ground to bring focus in excellent. Also had bad corona arcing due to a pinhole in the HV lead. It was sizzling pretty good to ground at the point where the lead exits the flyback cage. Replaced that with nos belden HV lead.
I hear all the stories about how everyone hated Motorola sets and how terrible the picture is. Im the first to say (with this particular set atleast) that the picture is pretty darn nice! I can't complain at all. The set is very congested inside. Motorola tried to copy zenith with the removable service plate on the bottom, point to point construction with the solder cones and the dynamic convergence board behind the removable speaker. Quality of build is not close to a zenith. Factory soldering is much more sloppy and wire dress is not very neat. Perhaps the engineers at zenith and motorola went out to lunch together and shared ideas, the plants were only a few miles apart It’s definitely a keeper though for its rarity and working so nice.
Attached Images
File Type: jpg 68moto5a.jpg (108.3 KB, 27 views)
File Type: jpg 68moto6a.jpg (112.4 KB, 24 views)
File Type: jpg 68moto7a.jpg (97.5 KB, 26 views)
File Type: jpg 68moto8a.jpg (62.8 KB, 21 views)
File Type: jpg 68moto10a.jpg (57.2 KB, 22 views)
File Type: jpg 68moto11a.jpg (64.7 KB, 28 views)
File Type: jpg 68moto12a.jpg (46.2 KB, 36 views)
File Type: jpg 68moto13a.jpg (45.4 KB, 33 views)
__________________
I tolerate the present by living in the past...
To see drh4683's photo page, click here
To see drh4683's youtube page, click here
Reply With Quote