|
The "TV Signal Output" is a RF output using a RCA connector instead of the usual "F" connector and is switched by the RF channel selector. An RCA to F connector adaptor should get the signal to the set via the selected channel. The "Aux" outputs are pure video and audio to be connected to the set via the "video/audio" input connectors. RCA for the audio and BNC for the video. BNC to RCA adaptor needed for most modern sets.
I'm not sure if the antenna and player connectors in pix #2 are the same input and output like a VHS setup. Do you have a pix of the adaptor? That would help to guess on how this is connected.
The problem with the early...including this Maganavox...is the laser tube. This unit is a helium-neon laser tube which was prone to failure.
From Wikipedia;
"The earliest players used Helium-neon laser tubes to read the media with red-orange light, later players used infrared semiconductor laser diodes. You are unlikely to run into one of the tube players now, in part because of the limited operating lifetime of laser tubes, but mostly because they represent only a small fraction of the total players made. Optical hobbyists have also been known to cannibalize the laser tube machines, further depleting their ranks."
It could be electronically designed that if the video information (and it's associated sync signal) is missing, the unit would not output anything on the RF port. The same as a VHS with a clogged head that just gives you a blue screen.
Your best bet is to look at the Aux Video out. This would be before the RF output. If nothing is there, you probably need a laser tube.
Good luck! LaserDiscs are my new vice just after battery radios and televisions. And that is a very stylish looking unit compared to the later boxy units.
This could also be an interesting new category for old video recording mediums on AK. So many out there like the Akai 1/4" R/R (both B&W and color) and the CartriVision systems.
Dave A
|