![]() |
Montgomery Ward (Sylvania chassis, OEM NAP) Tuner Trouble
First off I'm pretty ignorant when comes tuners especially the ones in TVs as I have not had to mess with them much. The last thing I need to fix is tuner on this set. Please look at videos provided in link. Video 1 is what happened when I first got the set. Since than I have repaired a bunch of cold solder joints and capacitors that had gone bad. Yes I did open the tuner it's self and there was one bad capacitor and made sure not to touch any of the coils. On video 2 which is test after service(sorry in advance for poor camera work). If anyone has any ideas wear I should I be looking at IF on main board or is it problem in the tuner module itself. I will continue to look around and with Sam's im going to check the voltage on the pins on IC601.
https://drive.google.com/drive/folde...cv5ecr0ODXEvBy (also a copy of service manual and chassis is 26C616) https://archive.org/details/36112731...93729186_n.jpg |
If you're getting snow like that, it seems the tuner and IF amplifier are working.
Guesses: May be a problem with AGC or sync (which could be on the same module as the IF), or a connection between modules, or a ground connection. |
Quote:
Results: Pin 3 .7v the Sam's says .6 volts Pin 4 11v the Sam's says 4.7volts ( 4.5 -11volts ) RF AGC range Pin 14 12v the Sam's says 7volts ( 6.7- 11volts ) IF AGC range Some other pins were reading not what the schematics said they should. I will go and check the connection between the modules. Also I will check the grounds as this TV has had bunch of cold solder joints I had to fix. |
Pins 4 and 14 are far out of spec. Have you checked all the power supply voltages?
|
Quote:
Pin 14 ( 6.7- 11volts ) IF AGC range. So it is in range and its like it's trying to drive the gain as hard as it can like a weak signal. |
Quote:
|
I know for a fact that the replacement chip was a defective part I'm going to try with another chip I had SK7635 but I'm going to use an NTE1413 chip as I got 5 of them for $4 a peace with free shipping in there original bag.
|
Digging around in parts I have i found a genuine OEM chip for the TV made no difference. I rechecked the RF/AGC with signal and have 8.1 should be at 4.7 but can range as high as 11volts. On the IF/AGC I get 6.9 which is close enough to 7volts. The RF AGC with no signal goes to 9volts. The RF/AGC goes through a few passive components which I have checked and are good. After that it leaves to TS-9 module on connector J8. On that module it's has only part a 22uf cap which is good. Then it goes to connector J22 back to U/V tuner module 3402910001. I have resolder all the connection so it looking like its the tuner module. The TV works fine on AUX inputs (composite in) the only part in If haven't tested because I don't now how is SAW filter the IF goes in to it and then it splits off the video and audio.
PS I have added some pictures of in side the the set please click on first link that will take you to the Google drive where the files are keeped. |
| All times are GMT -5. The time now is 11:30 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.