Videokarma.org TV - Video - Vintage Television & Radio Forums

Videokarma.org TV - Video - Vintage Television & Radio Forums (http://www.videokarma.org/index.php)
-   Diagnostic & Test Equipment (http://www.videokarma.org/forumdisplay.php?f=177)
-   -   Series Power Supplies? (http://www.videokarma.org/showthread.php?t=249267)

j4570 11-07-2010 01:25 PM

Series Power Supplies?
 
I need 90 VDC to test an old battery radio.

Can I hook up a couple of triple power supplies (each is 5V/20V/20V and can be added together for 45V, then I need two of them) to get 90 VDC? Or is there some ground problem/issue I am not aware of?

I'll post over in videokarma too, since this is for an old radio.

bandersen 11-07-2010 01:49 PM

It depends on the power supply. If the outputs are floating (negative terminals are not tied together internally), it should be fine. I use an HP 6228B dual 0-50V connected in series to get 90 volts.

j4570 11-07-2010 02:31 PM

I can do the supply itself.

What about using two seperate supplies??

Jason

bandersen 11-07-2010 03:45 PM

Again it depends on the supply. If the negative terminal is connected to either the neutral or ground on the AC plug, it won't work.

perhaps you could just build a 90 volt supply from scratch ? Here's a very simple transformerless circuit http://www.antiqueradio.org/bsupply.htm

j4570 11-07-2010 05:29 PM

I ran across that page a while back, forgot about it. I might do that if I don't do somehting else. The radio I have only needs 1.5V and 90V. I guess I could always go the 10 9V route.

I want to see if this works before I construct a permanent supply for it.

I'll look on E-bay for a bigger supply, always a good excuse........

Jason

Reece 11-08-2010 02:18 PM

You could go to the dollar store and buy ten cheap 9-volt transistor batteries and snap them together + to - and get 90 volts for your test. You might be surprised how long they would last, too. If you need intermediate voltages just capture a wire between snapped terminals at the appropriate point between batteries. Ditto for your 1.5 volt supply: put a couple of D cells in parallel for more amp-hours.

j4570 11-08-2010 05:30 PM

I was under the impression that the 9V's wouldn't last that long. Looks like from some basic informaiton, Alkalines would last at least 10 hours.

If I had enough AA battery holders (I used to have tons for old CB's, 8 each for 12 Volt, probably tossed them), I could get close with AA rechargeables I bet. Well at least 1/2 there.

Jason

Findm-Keepm 11-11-2010 07:27 PM

http://home.comcast.net/~morrised200...structions.pdf

Simple!

Cheers,


All times are GMT -5. The time now is 12:11 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.