andy
11-16-2006, 01:01 AM
...
|
View Full Version : CTC12 vertical andy 11-16-2006, 01:01 AM ... rcaman 11-16-2006, 01:25 AM on my set i replaced the orange drop capacitors on that board and then all was well. steve andy 11-16-2006, 12:28 PM ... bgadow 11-16-2006, 12:56 PM I had vertical issues with one of those RCA 18" hybrids-only replacing the orange drops (probably maroon) took care of the problem. In that case, with a vertical chassis, heat seemed to have killed them. I would agree though that 9 times out of 10 those caps are good. Also make sure the pots are good. I spent a good amount of time troubleshooting one set with a short verticle only to find that either the height or lin (can't recall) was burnt. It worked to a point but not fully. andy 11-16-2006, 01:54 PM ... blue_lateral 11-16-2006, 03:21 PM Isnt there an tubular electrolytic in that circuit? No schematic in front of me right now, but I think it causes insufficient deflection if it's bad. John drh4683 11-16-2006, 04:26 PM yep, bad orange drops do happen occasionally. Lots of times the zenith table b/w sets will have short vertical. Ive found it to be a bad (leaky) maroon drop .0068uF in the output circuit. Had this happen about 3 times already (different sets of course). I lost vertical sweep in a CTC-16 I bought from Tim a few years back. that was caused by a shorted orange drop which in turn smoked the B+ dropping resistor to the vertical output plate. I can't remember exactly but it was something like a .1uF. Faulty mylars are indeed a rare occurance though. andy 11-16-2006, 06:10 PM ... blue_lateral 11-16-2006, 07:33 PM Varistor. 1480v 15% 10ma. RCA # 112876 andy 11-16-2006, 08:50 PM ... andy 11-17-2006, 12:20 PM ... fujifrontier 11-17-2006, 09:49 PM hmm. how can you determine the amount of hours on the chassis? andy 11-17-2006, 11:16 PM ... fujifrontier 11-17-2006, 11:33 PM Oh. I see. I wasn't asking it as a smartass question BTW. andy 11-18-2006, 03:48 AM ... Bobby Brady 11-18-2006, 04:06 PM I wonder where I could find something like that? Any ideas on substitues? had some old stuff like varistors for sets but I won't be likely to visit there for a month or so. andy 11-26-2006, 08:48 PM ... andy 11-27-2006, 01:19 AM ... Don Lindsly 11-27-2006, 01:36 PM Check the electrolytic cap in the vertical output cathode that feeds the convergence panel(which must be plugged in). Make sure the solder grounds on the vertical PC are solid. |