I created my account a week or two ago, but haven't had time for posting yet. I am new to collecting CRTs. I found this remote lying around in my basement, and I would like help identifying which TV it went with (all I know is that the TV was a 1980s Zenith). Any help is appreciated.

Pictures:

https://drive.google.com/file/d/12ifHzc9_nyKbn4-t8W1R8oCvnFvouBrn/view?usp=sharing

https://drive.google.com/file/d/12hPMqMcSVyA0pDA1gJvPZ4MB3Xi1QzYe/view?usp=sharing

Welcome!

Welcome to the forum. RonL

Welcome.

This looks like a VCR remote, are you sure it's for a Zenith TV?

Welcome.

This looks like a VCR remote, are you sure it's for a Zenith TV?

I looked at it again, and noticed it has a sliding switch on it that says "TV" on the right and "VCR" on the left.

All my VCR remotes have that switch. It's so you can control the TV with the same remote you use with the VCR.
Remotes that ship with the TV only have TV functions. If it has buttons for transport control then it's a VCR remote which came with your Zenith VCR.

All my VCR remotes have that switch. It's so you can control the TV with the same remote you use with the VCR.
Remotes that ship with the TV only have TV functions. If it has buttons for transport control then it's a VCR remote which came with your Zenith VCR.

Ah, ok. I didn't know that. Thanks for the clarification. I initially asked about what the remote went with, since my dad told me it was from a TV he had years ago. I hope to find the IR sensor that remote went with so I can add remote control capability to my new project. Now I want to find the matching VCR as well, as it was probably thrown out years ago.

https://drive.google.com/file/d/12gJKZMrCnVoyACgpbxsjXPg5kee4TLK-/view?usp=sharing
Picture of said project, for those who are wondering

Is that a DTV converter box? Mine already has remote control. But I'm not sure what's going on in the picture.
If you need IR LEDs/sensors you can get them on Digi-Key or Adafruit (if you're in NY)...

That is indeed a DTV box. The TV I found for free at my local waste dump. It's a Zenith A1926W from 1984. I'll post more about it in the Solid State CRT TVs section.

Welcome to VK!

Welcome aboard!

Your remote is from when Zenith sold JVC built VCR's. It will
run almost any Zenith TV IR remote. Uses a J type battery. Millions
are out there as a Zenith VCR comes with one also.

The A1926W is non remote. Zenith remote model would start with "S".
IIRC the comparable remote to yours is SA1927W. You cant add
remote, it takes a LOT more than an IR detector.

Zeno:smoke:
LFOD !