View Full Version : Farnsworth 651p TV - what to do with it? Videokarma's opinion?


ronl
06-27-2014, 07:17 AM
How's it going members?
i asked this on arf in 2010 when i discovered that site and got different opinions.
just curious what videokarma members think?
#1 should i re-cap it
#2 dont touch it and leave it as original as possilble?(i did some small vert repairs when i got it in 1982-iirc-was mostly original parts except for pix tube and 0 tubes-had most tubes in stock back then).
#2 if i do recap it, is this set rare enough to restuff caps for originality?
#3 how many 651p tvs are out there and how many work?(mine still worked a few years ago when i did these youtubes-wont risk powering it up again until a recap) http://www.youtube.com/watch?v=PR8JU9uhi78 http://www.youtube.com/watch?v=9EKBFUSVHF4

most arf members figured that i should recap but a bunch figured that i should leave as-is due to the rareity.

thanks to aft for the service data and missing knobs(still gotta source a speaker for it and a lock-good luck on finding a lock-ha!

comments pls?

here are the original arf forum links - got lots of pms about this set as well. http://www.antiqueradios.com/forums/viewtopic.php?f=3&t=122536 http://www.antiqueradios.com/forums/viewtopic.php?f=3&t=143501 http://www.antiqueradios.com/forums/viewtopic.php?f=3&t=249824
i'm still on the fence about the best way to deal with this set.

cheers,
RonL

WISCOJIM
06-28-2014, 08:05 AM
I'd restuff when I recap it, to preserve the original look and also have the set useful.

I wouldn't want to buy an antique car and not be able to drive it, why any different with an antique TV?

.

ronl
06-29-2014, 07:26 AM
i hear ya WISCOJIM.many thanks for the advice.
but i have also been advised to leave as is (keep as original as possible) because of the rareity of this set? ordinarily i would re-cap but i havent seen many of these sets over the years.still not sure what do do at this point...
any other members want to give thier "2 cents worth"?
have a good one,
RonL

bandersen
06-29-2014, 03:49 PM
I would do a careful restoration including restuffing the caps and using old carbon composition resistors.